Back

Indian Motorcycle Maintenance

Jan. 10 2023 Miscellanous By Service Department

Share

Indian Motorcycle Maintenance Guidelines


Break-In Maintenance


Break-in maintenance is due when the motorcycle’s odometer registers 500 miles (800 km). Call Hattiesburg Cycles at 601-582-8611. Performing the break-in maintenance will help facilitate optimum engine performance for the entire service life of the engine. Your dealer will change engine oil, inspect all fluids and serviceable components, tighten all fasteners and make other adjustments as needed.


Periodic Maintenance
Inspect, clean, lubricate, adjust and replace parts as necessary. When inspection reveals the need for replacement parts, use genuine Indian Motorcycle parts available from your dealer or online at the online parts catalog. Always record service and maintenance information in the Maintenance Log at the end of your Owner’s Manual. 
Notice: Use of non-recommended lubricants and components can result in damage to the motorcycle. Damage resulting from the use of non-recommended products is not covered by warranty. Any Hattiesburg Cycles employee would be happy to show you which products will not interfere with your warranty.
Perform maintenance at the intervals specified in the following maintenance interval charts. Vehicles subjected to severe use must be inspected and serviced more frequently. 
Severe use includes: 
• High or low speed at long periods of time 
• Operation in dusty or otherwise adverse conditions 
• Operation in weather that is 32 degrees Fahrenheit or below


There are maintenance schedules that can be downloaded to keep track of your service better.


Road Tests
After service, test your vehicle somewhere safe and alone.  Check the brakes, acceleration, and throttle. Ask any Hattiesburg Cycles service employee on a suggestion.


Major Maintenance
When maintenance is a bigger issue, it usually takes a dealer diagnostic to give the technician a complete understanding of the problem.


Safety During Service Procedures
Warning: Failure to follow all recommended precautions and procedures could result in serious injury or death. Always heed all safety precautions and follow all operation, inspection and maintenance procedures outlined in the Owner’s Manual. 
• Improperly installed or adjusted components can make the motorcycle unstable or hard to handle. Improperly installed electrical components can cause engine or electrical system failure. In either event, damage or serious injury could result. If you do not have the time, tools and expertise necessary to complete a procedure properly, please see your dealer for service. 
• Review the safety-related maintenance information in the Safety Maintenance section. 
• Before beginning any maintenance procedure, read the instructions for the entire procedure. 
• Always position the motorcycle on a firm, level surface before performing service. Make sure the motorcycle will not tip or fall while elevated or while on the side stand. See the Elevating the Vehicle section of your Owner’s Manual for details. 



• Hot engine and exhaust components can cause burns to skin and can ignite a fire if exposed to flammable materials. Always Park the motorcycle clear of flammable materials and where people are not likely to contact hot components. 
• Wear eye and face protection when using pressurized air. 
• Never start the engine or let it run in an enclosed area. Engine exhaust fumes are poisonous and can cause loss of consciousness or death in a short time. 
• During some procedures you may use potentially hazardous products such as oil or brake fluid. Always follow the instructions and warnings on the product packaging.


While, it is you choice whether on not you choose an authorized dealer like Hattiesburg Cycles to perform all of your routine maintenance or go about it yourself.  It is always best to take a breath, calm down and reqroup.  Hattiesburg Cycles Service department is here to serve you. QUALITY MEETS SPEED!!!